Copyright © Dr Robot Inc. 2005
18
Disconnect with
modem_control_in drop (6)
1
Ignore modem_control_in
0
Telnet mode and terminal type
setup (1)
1
Channel (port) password (2)
1
Hard disconnect (3)
0
Disable hard disconnect
1
State LED off with connection (4)
1
Disconnect with EOT (^D) (5)
1
(1) The WFS802g sends the "Terminal Type" upon an outgoing connection.
(2) A password is required for a connection to the serial port from the network.
(3) The TCP connection closes even if the remote site does not acknowledge the disconnection.
(4) When there is a network connection to or from the serial port, the state LED turns off instead of
blinking.
(5) When Ctrl D or Hex 04 is detected, the connection is dropped. Both Telnet mode and
Disconnect with EOT must be enabled for Disconnect with EOT to function properly. Ctrl D is only
detected going from the serial port to the network.
(6) When modem_control_in transitions from a high state to a low state, the network connection to or
from the serial port drops.
Flush Mode
The FlushMode (buffer flushing) parameter controls line handling and network buffers with connection
startup and disconnect.
FlushMode ( 0) ?
Select between two different packing algorithms (the current configuration is displayed within the
parentheses). Available Flush Mode options are:
Table V.11. Flush Mode Options
Function 7
6
5
4
3
2
1
0
Input Buffer (Serial to Network)
Clear with a connection that is
initiated from the device to the
network
1
Clear with a connection initiated from
the network to the device
1
Clear when the network connection
to or from the device is disconnected
1
Output Buffer (Network to Serial)
Clear with a connection that is
initiated from the device to the
network
1
Clear with a connection initiated from
the network to the device
1
Clear
when
the
network
connection
1
