Copyright © Dr Robot Inc. 2005
7
control.
2. Reset the WFS802g unit by cycling the unit's power (turning the power off and back on).
Immediately upon resetting the device, enter three lowercase x characters (xxx).
Note:
The easiest way to enter Setup Mode is to hold down the x key at the terminal (or
emulation) while resetting the unit. This must be done within three seconds of resetting the
WFS802g.
3.
Upon connection, the following information displays:
Figure V.3. MAC Address
MAC address 00204AFFFF30
Software version 05.3 (040129) WPT
Press Enter to go into Setup Mode
4.
To enter the Setup Mode, press Enter within 5 seconds
Note:
Connection fails if Enter is not pressed within 5 seconds.
The configuration settings display, followed by the setup menu options:
Figure V.4. Setup Menu Options
Change Setup:
0 Server
1 Channel 1
2 Channel 2
3 Email
4 WLAN
5 Expert
6 Security
7 Factory defaults
8 Exit without save
9 Save and exit Your choice ?
5.
Select an option on the menu by entering the number of the option in the Your choice ? field and
pressing Enter.
View the current configuration by pressing Enter from the Change Setup menu. To enter a value
for a parameter, type the value and press Enter. To confirm a current value, press Enter
(without inputted parameters).
6.
When finished, save the new configurations (9 Save and exit). The unit reboots
