Doro IP500PBXW, Руководство пользователя

Страница: 14 / 166

Administration Manual ip500pbxw – English
13
Step 5 ip520c DECT Phones
Assemble your ip520c DECT Phone
Place the 2 rechargeable NiMH batteries size AAA 1.2V 750mAh (included), observing their polarities, into the battery
compartment of the handset. Slide the battery door firmly into place.
Place the handset on the charger unit and let the batteries charge for a full 14 hours before using it for the first time. The
handset may get warm during initial charge.
Register the DECT phones.
Press the ‘Page’ button for
4 seconds
. This button is located on the front of the system. This places the system in
registration mode for 30 seconds.
Note
You will know that the system is in registration mode when the
power led flashes red and green
On the DECT handset, press
REG
on the DECT phone
Press
OK
for
REGISTER
Enter the
PIN
number of 1234
Press
OK
The DECT handset is now registered to the system
Note
Pressing the ‘Page’ button normally (for less than 2 seconds)
rings all DECT phones registered to the system. This can be
used to locate misplaced DECT phones.
Safety precautions:
Do not allow the DECT handset to come into contact with liquids or moisture.
Do not allow the charging contacts or the battery to come into contact with conductive materials.
Do not use the handset in an explosive hazard area such as where there is gas leaking.
Because the DECT handset works by sending radio signals between the base unit and the handset, wearers of hearing
aids may experience interference in the form of a humming noise.
We advise that the DECT handsets should not be used near intensive care medical equipment or by persons with
pacemakers.
Your DECT handset can interfere with electrical equipment such as answering machines, TV and radio sets, clock radios
and computers if placed too close. It is recommended that you position the System at least one meter from such appliance
WARNING
Use only the mains adapter supplied with the DECT handset. Incorrect
adapter polarity or voltage can seriously damage the DECT Handset.
Input: 230 VAC 50 Hz Output: 9 VDC 300 mA.
WARNING
THERE IS A RISK OF EXPLOSION IF THE BATTERY IS REPLACED
BY AN INCORRECT TYPE. Never use non-rechargeable batteries. Use
two rechargeable NiMH batteries, size AAA 1.2V 750mAh (HR10/44)
only. NiMH batteries must be disposed of in accordance with the
applicable waste disposal regulations.