OP000468
1-31
Safety
Do not carry out deep digging under the front of the
machine. The ground under the machine may collapse and
cause the machine to fall.
Working heavy loads over loose, soft ground or uneven,
broken terrain can cause dangerous side load conditions
and possible tipover and injury. Travel without a load or a
balanced load may also be hazardous.
Never relay on lift jacks or other inadequate supports when
work is being done. Block tracks fore and aft to prevent any
movement.
When using the machine, to prevent accidents caused by
damage to the work equipment and overturning because of
an excessive load, do not use the machine in excess of its
ability (in terms of the maximum load and stability
determined by the structure of the machine).
When working at the edge of an excavation or on a road
shoulder, the machine could tip over, possibly resulting in
serious injury or death. Investigate the configuration and
ground conditions of the work site beforehand to prevent the
machine from falling and to prevent the ground, stockpiles,
or banks from collapsing.
Precautions for Operation
Be careful not to mistakenly travel too close to the edge of
a cliff.
Use the machine only for its main purpose. Using it for
other purposes will cause failures.
To ensure a good view, always do the following:
•
When working in dark areas, attach working lights
and front lights to the machine. If necessary, set
up lighting at the work site.
•
Stop operations when the visibility is poor, such
as in fog, mist, snow, and rain. Wait for the
visibility to improve to a level which causes no
problems for the operation.
FG006344
Figure 21
FG006345
Figure 22
Содержание DX35Z
