DOM GUARD S, Руководство по сборке и эксплуатации, Страница: 77 / 96

Using handle
77
Using handle
Putting the handle into operation
In order to put the handle into operation without using the app or
software, you require the master card for setting the affiliation with the
system. Setting the affiliation with the system must be undertaken once
for each handle. Make sure that the master card is protected against
unauthorised access. If the master card is lost, you must pay a fee to
have the handle reset in the factory and newly programmed. Contact
your dealer for this purpose.
Programming with the master card and the programming card is carried
out on each handle. Only perform programming when the door is open,
so that you do not lock yourself out.
The cylinder automatically detects transponders when they approach the
handle’s reading field. In rare cases, interference fields or the use of
transponders that are not approved by DOM Sicherheitstechnik can lead
to transponders not being detected.
➢
Only use transponders which are approved by DOM
Sicherheitstechnik for use with the handle.
➢
Hold the transponder right on the reading field of the handle.
➢
If the transponder is nevertheless not recognised, make sure that no
interferences have an effect on the handle.
The handle is in the mode “Permanently open” on delivery. You can
open the door without holding a transponder to the reading field.
➢
You must put the handle into operation in order to use the security
function of the handle.
You can find further information about putting into operation,
programming and use in the instructions for use for the programming
medium used which are supplied.
Proceed as follows to initialise the handle:

Briefly hold the master card in front of the respective reading field.
The yellow LEDs light up once for a long time. Then the handle signals its
initialisation by means of the short red, green, yellow and blue signal
sequence and then by the long yellow signal sequence. The handle restarts
following successful initialisation. The handle can then be programmed with
the master card, programming card or software and app products.