Docomo FOMA P701iD, Руководство пользователя

Страница: 82 / 580

80
Making/Receiving
Video-phone
Calls
●
Note that when you make a video-phone call sending a substitutive image, you will be charged for the digital transmission.
●
You can make video-phone calls to any DoCoMo video-phone, no matter the type.
●
If you dial 110, 119 or 118 using the video-phone function, the number will be automatically dialed out as a voice call.
●
You cannot receive mail and Messages R/F during a video-phone call. Incoming mail and Messages R/F will be held at the i-mode Center.
You can retrieve them using “Check new message”, after you end the video-phone call.
However, you can receive SMS messages during a video-phone call.
●
During Hands-free use, be sure to keep the FOMA phone away from your ears. Otherwise, you could affect or damage your hearing.
●
If the battery runs low during a video-phone call, the message “Recharge battery” appears and the substitutive image is sent to the
other party. However, if you set “Chara-den” as a substitutive image, the “Pre-installed” substitutive image is displayed. If you charge
the battery during a video-phone call, the image set for “Substitutive image” of “Select image” is displayed.
● You cannot make a video-phone call by entering a phone number while “Keypad dial lock”, “Restrict dialing” or “Self mode” is activated.
●
The International video-phone call is available using the DoCoMo International Call Service “WORLD CALL”. (See page 54)
Information
■
Auto-redialing
If the video-phone call is not connected, dialing at 32K or the voice call is automatically made.
●
The video-phone call by 32K speed is provided to connect with PHSs and similar devices that cannot be connected at 64K
depending on the network conditions. When you dial a 64K video-phone call to the phone that can be connected only at 32K, the
dialing speed will be switched automatically to 32K.
＊
The same digital transmission charge applies to the 32K video-phone connection and 64K digital connection.
●
Video-phone calls cannot be connected to phones if they do not support the video-phone function, are out of the service area, or
are switched off. If you have set “Voice call auto switch” to “ON” and attempt to dial a phone that does not have the video-phone
function, the video-phone call will be cut off and the number will be redialed as a voice call. Note that this setting might not work if
you call an ISDN synchronous 64K or PIAFS access point or an ISDN video-phone that does not support 3G-324M (as of August
2005), or if you dial the wrong number. Nevertheless, you could be charged for the call.
●
Once the video-phone call has started communications, redialing as the voice call will not be made.
Voice call auto switch “ON” Voice call auto switch “OFF”
Could not connect by dialing at 64K. Dials again at 32K. Dials again at 32K.
Could not connect by dialing at 32K. Dials again by the voice call. Does not dial again.
While entering a phone number ( ) Do the following operations.
1
Function Menu while Entering Phone Number
Function menu
Notify caller ID
Prefix numbers
International dial
Multi number
Add to phonebook
Compose message
Dialing speed
Select image
Operations
You can set whether to notify your caller ID. (See page 50)
You can add a prefix number. (See page 62)
You can make an international call. (See page 56)
See page 456.
You can store the data in the Phonebook. (See page 103)
You can compose a mail message to send to the phone number set as the destination address.
Go to step 3 on page 245.
You can set the dialing speed per video-phone call.
64K··················For dialing video-phone calls at 64K.
32K··················For dialing video-phone calls at 32K.
You can select an image for the video-phone call. (See page 91)