Docomo F-01A, Инструкция по эксплуатации, Страница: 112 / 519

110
Security Settings
Security code
Security code used on the FOMA terminal
Some of the convenient FOMA terminal functions require entry of security code. In
addition to the terminal security code for using some terminal functions, there are
several types of security codes such as network security code for network services
and i-mode password. Use these codes appropriately for FOMA terminal.
･
The terminal security code, network security code or i-mode password entered is
masked with " ".
Precautions related to security codes
･
When setting a security code, do not use a number that can be easily known to
others, such as "birthday", "a part of a phone number", "street address or room
number", "1111" or "1234". Keep a separate note of the set security code.
･
Be careful never to reveal your security code to others. If a security code is
known to and misused by others, DOCOMO assumes no responsibility for
damages resulted from it.
･
If you forgot your security codes, or fingerprint authentication for all of the
fingers registered is unavailable when Fingerprint access is "ON", you need to
bring a document (such as a driver's license) for identifying that you are a
subscriber, FOMA terminal and UIM to a DOCOMO Shop.
For details, contact the phone number for "General Inquiries" on the back of this
manual.
❖
Terminal security code
The default security code is "0000", which you can change by yourself.
→
P111
･
If a wrong terminal security code is entered 5 times consecutively, the power is
turned OFF.
･
For the setting using Verify fingerprint, the fingerprint authentication screen
appears instead of the terminal security code entry screen. Press
m
to switch
the terminal security code entry screen. The terminal security code cannot be
entered when Fingerprint access is "ON".
❖
Network security code
Network security code is a 4-digit number used when DOCOMO identifies the
subscriber to accept orders at DOCOMO Shop, docomo Information Center or " 各種
お申込・お手続き (Application/Procedures)" or when you use a variety of Network
Services. You can set any number at subscription and optionally change it later.
If you have "docomo ID/Password" for "My docomo" that is a total support site for
a PC, you can change your network security code from a PC.
From i-mode, you can change the code by yourself accessing " 各種お申込・お手続
き (Application/Procedures)" in お客様サポート (Support).
･
For "My docomo" and " 各種お申込・お手続き (Application/Procedures)", see the
inside of the back of this manual.
❖
i-mode password
The 4-digit "i-mode password" is required to save to/delete from
マイメニュー
(My
Menu) or subscribe to/cancel Message Service or i-mode charged services. The
password is set to "0000" by default, however, you can change it by yourself.
→ P174
There may be passwords required by individual IPs (Information Providers).
❖
PIN code/PIN2 code
2 security codes which are the PIN code and PIN2 code can be set for UIM. Their
security codes are set to "0000" by default, which you can change by yourself.
→
P112
PIN code is a number (code) to be entered each time UIM is installed or FOMA
terminal is powered ON to confirm the user and to prevent unauthorized use of
FOMA terminal. Making/Receiving calls and terminal operations are enabled by
entering PIN code.
The PIN2 code is the security code to be used when requesting the issuance of a
user certificate, resetting Total calls cost or changing settings of Reset call cost.
･
When installing UIM that has been used with another FOMA terminal, the PIN
code and PIN2 code should be the same ones set previously. If no changes have
been made to PIN code and PIN2 code, your codes are "0000".