Docomo F-01A, Инструкция по эксплуатации

Страница: 96 / 519

94
Sound/Screen/Light Settings
Setting System sound
Keypad sound : Set a sound to be emitted when pressing keys (except
P
,
M
,
SD
),
operating pointing device or operating in flip style.
･
When the sound of Battery level and End alert of Data exchange settings are set
to "ON", sounds are emitted according to these settings.
･
When setting to "OFF", the confirmation sound is not emitted when reading a
code.
･
Keypad sound is not emitted in the cases below even if it is set to ON.
- When i-
α
ppli is activated (except
s
)
- When Full Browser is activated, or when the pointer is moved by sliding the pointing device
- When sliding or quickly sliding in flip style
･
When setting to "Sol-fa", the dedicated sound is emitted by double-tapping the
pointing device, "Key sound 2" is emitted by sliding the pointing device or
touching or double-touching in flip style.
Open/Close sound : Set a sound to be emitted when opening/closing FOMA
terminal.
Shutter sound : Set a shutter sound when shooting a still image.
･
This setting also applies to Shutter sound of Image settings.
Movie camera sound : Set a shutter sound when recording a movie (including
recording a sound with Sound recorder).
･
This setting also applies to Shutter sound of Recording settings.
1
m
[Settings & NW services]
116
2
Perform necessary operation
Setting Keypad sound :
1 e 1
-
5
Setting Open/Close sound :
2 e 1
-
4
Setting Shutter sound :
3 e 1
-
5
Setting Movie camera sound :
4 e 1
-
5
Charge alert
Setting confirmation tone for charging
You can set if you activate the battery charging sound at the start and end of
charging.
1
m
[Settings & NW services]
117 e 1
or
2
✔
INFORMATION
･
Even when "ON" is set, the charge alert does not sound in the cases below.
- In Silent mode, Public mode (Drive mode), during a voice/videophone call, PushTalk session, 64K
data communication, i-mode communication, packet communication
Setting Call session
On-hold tone : Set On-hold tone.
Quality alarm : Set alarm sound when the call is about to be interrupted.
･
The call may be interrupted without sounding the alarm depending on the call
conditions or radio wave conditions.
Reconnect alarm : Set alarm for reconnecting interrupted call.
･
While the call is interrupted, the other party hears no sound.
･
The time required for reconnection differs depending on the call conditions or
radio wave conditions. It normally takes 10 seconds at most.
･
You are charged for the time used for reconnection (up to 10 seconds).
･
The call may be interrupted without sounding the alarm depending on the call
conditions or radio wave conditions.
Low Battery alert : Set if you activate the alarm when the battery is about to be
exhausted.
･
When the battery becomes low during a call, the alert is emitted from the earpiece
even with "OFF" set.
1
m
[Settings & NW services]
118
2
Perform necessary operation
Setting On-hold tone :
2 e 1
-
3
Setting Quality alarm :
3 e 1
-
3
･
Operation during a voice call :
m5
Setting Reconnect alarm :
4 e 1
-
3
･
Operation during a voice call :
m4