DoAll TF-2025M, Инструкция по эксплуатации

Страница: 28 / 34

24
BANDWHEELS
1. Occasionally check each bandwheel’s back-up
flange and wheel tread for wear. Saw bands will
not track properly if the taper is worn from the wheel
tread.
2. Replace the entire bandwheel if the rim becomes
badly worn.
3. Ideally, the saw band should be tracking on both
wheels so that the back edge will just lightly contact
the wheel flanges, or is not more than 0.005 inch
(0.127 mm) away from the flanges.
Typical Bandwheel Flange and Tread.
CLEANING OPTIONAL CHIP CONVEYOR
1. To clean the optional chip conveyor, turn the machine
off. Then: (a) Disconnect the coolant hoses; (b)
Pull the conveyor out from its cradled position in
the base; (c) Clean the conveyor trough; (d) Clean
out the chip box and the reservoir floor; (e) Replace
the conveyor.
HEAD ANGLE DISPLAY CALIBRATION
1. If some unusual event or a repair has been made,
it will be necessary to calibrate the saw head angle
display.
2. Calibration procedures are as follows: (a) Remove
the back panel from the operator control console
panel support; (b) Note the location of a pushbutton
on the bottom of the operator panel. This is the
Dsplay Zero pushbutton.
3. Tilt the saw head until it is against one of the physical
stops. Push the Dsplay Zero pushbutton. The
Head Angle Dsplay will read 0°.
4. Move the saw head towards the vertical until the
Head Angle Dsplay reads 60.5°.
5. Push the Dsplay Zero pushbutton. The Head
Angle Dsplay will read 0°. The saw head is
now perpendicular to the vise table. Reinstall the
back panel on the operator control console panel
support.