DoAll TF-2025M, Инструкция по эксплуатации

Страница: 32 / 34

28
ACCESSORIES
ROLLER STOCK CONVEYORS
1. Your machine may be equipped with one of the
following roller stock conveyors for moving long
stock into cutting position (or as an unloading
adjunct). The following conveyors are available:
• Stock conveyor five (5) feet (1524.0 mm) long by
22 inches (558.8 mm) wide with a weight capacity
of 750 pounds (340.2 kg) per roller.
• Stock conveyor ten (10) feet (3048.0 mm) long by
22 inches (558.8 mm) wide with a weight capacity
of 750 pounds (340.2 kg) per roller.
Roller Stock Conveyor.
2. To install a roller stock conveyor: (a) Position
the assembled conveyor(s) behind or in front of
the machine base; (b) Adjust the conveyor to the
machine with the leveling screws on the conveyor
legs. The top of the front conveyor roller should be
inline to 0.010-inch (0.25 mm) above the vise bed
wear plate.
3. The remaining rollers must be parallel to, and in the
same plane with the vise beds to within 0.010-inch
(0.25 mm) per 24 inches (609.6 mm) of travel.
4. Depress the roller shafts for ease of installation of
rollers.
The conveyor DOES NOT attach to the machne
base. Anchor the conveyor to the floor after
all levelng and adjustments are made.
VERTICAL GUIDE ROLLERS (For Conveyors)
1. Vertical guide rollers are effectively used to help
maintain correct positioning of long stock on the
conveyor.
2. These can be installed between the interface plate
and conveyor or between conveyors (if more than
one is supplied).
Vertical Guide Roller For Conveyors.
NESTING FIXTURE
1. This optional feature is designed for high-production,
multiple sawing of stacked bars, rounds and tubing.
Its jaws have the capacity to hold stock from 8 to
20 inches (203.2 to 508.0 mm) wide, and from 1.38
to 10.25 inches (34.9 to 260.3 mm) high.
2. Vertical nesting clamp cylinders are mounted to
the machine’s inboard and optinal outboard vise
tables. The cylinders operate simultaneously with
the regular vise clamping cylinders.
A negatve (-) angle tlt ot the saw head s NOT
permtted wth the left hand (nboard) Nestng
Fixture. NO tilting is allowed with both inboard
and outboard nesting fixtures.
The hydraulically-operated Nesting Fixture can
also be used wth the Varable Vse Pressure
control.
Stackng Stock
1. Correct stock nesting is essential for proper clamping
of the vises and nesting fixture. It is important that
nesting vise clamping pressure be transmitted
to every stacked piece. Sometimes this can be
more easily accomplished by manually jogging the
stack.
2. Proper stacking of round stock is important because
saw band breakage may occur if round nested pieces
slip or spin during sawing.