© 2001 Directed Electronics, Inc. Vista, CA
7
H1/10 BROWN (+) SIREN OUTPUT
Connect this to the red wire of the Revenger siren. Connect the black wire of the siren to (-) chassis ground,
preferably at the same point you connect the control module’s black ground wire.
H1/11 RED (+)12V CONSTANT POWER INPUT
Before connecting this wire, remove the supplied fuse. Connect to the positive battery terminal or to the con-
stant 12V supply to the ignition switch.
NOTE:
Always use a fuse within 12 inches of the point you obtain (+)12V. Do not use the 15 amp
fuse in the harness for this purpose. This fuse protects the module itself.
H1/12 RED/WHITE HIGH CURRENT OUTPUT FROM ON-BOARD CHANNEL 2 RELAY
Whenever the button(s) controlling Channel 2 is pressed for 1.5 seconds, the on-board relay is activated and will
stay active as long as the transmission continues. This relay is often used for trunk release. The relay can drive
circuits up to 20 amperes. The polarity of this output is determined by the connection of the input wire (H2/A)
on the Door Lock Harness.
NOTE:
If the input wire (H2/A) is not connected, there will be no output from the relay when it is
activated.
