© 2001 Directed Electronics, Inc. Vista, CA
31
3-3 CHANNEL 5 VALIDITY/LATCHED/LATCHED RESET WITH IGNITION/30, 60, OR 90-SECOND TIMED:
Channel
5 can be programmed for these output configurations. The unit is set to the default validity output. To change
the configuration, use Button II to toggle to the different settings.
3-4 CHANNEL 6 VALIDITY/LATCHED/LATCHED RESET WITH IGNITION/ TIMED:
Channel 6 can be programmed
for these output configurations. The unit is set to the default validity output. To change the configuration, use
Button II to toggle to the different settings. If the timed option is selected the default setting is 15 seconds.
To change the timed output, see Feature 3-5.
3-5 CHANNEL 6 DURATION 5/10/15/20/25/30 SECONDS:
If Channel 6 is programmed for a timed output
in Feature 3-4, it will output for 15 seconds. It is possible to select any time from 5-30 seconds in 5 second
increments. Each time Channel Two is pressed, the duration of the output is increased by 5 seconds. The unit will
chirp indicating the number of 5 second increments that have been selected (4 chirps would indicate 20
seconds). Once the unit chirps 6 times, the next input from the transmitter cycles the output back to 1 chirp
setting (5 seconds). If using the DEI Bitwriter or Techsoft programmer the timed output can be programmed from
1-90 seconds.
3-6 CHANNEL 7 SECOND UNLOCK/STANDARD CHANNEL:
The BLUE wire (H3/7) is usually used to progressively
unlock the doors of the vehicle. Pressing the disarm button again within 15 seconds of disarming will generate
a (-) pulse on the BLUE wire. If programmed for second unlock, the wire will also output a pulse when the igni-
tion controlled door lock feature unlocks the door. If this output is not used to progressively unlock the doors,
it can be used as a standard channel output. Programming the unit for standard channel output will prevent an
output from occurring whenever the ignition is turned off. The unit will no longer treat the output as a door lock
output, but instead as a standard output.
3-7 DOUBLE PULSE UNLOCK OFF/ON:
Some vehicles require two pulses on a single wire to unlock the doors.
When the double pulse unlock feature is turned on, the on-board unlock relay will supply two unlock pulses.
3-8 HORN HONK OUTPUT FLASHING/CONSTANT:
In the default setting the horn honk output (H3/6 BROWN) will
provide a flashing output to honk the horn in the full triggered sequence. This output can also be programmed
to honk the horn constantly during the full triggered sequence.
3-9 DISARM WITH CHANNEL TWO ON/OFF:
If programmed ON the security system will disarm whenever Channel
2 is activated with the remote transmitter. This is useful if Channel 2 is used for trunk release. When the trunk
is opened the system will disarm, preventing the alarm from triggering.
3-10 GROUND-WHEN-ARMED (GWA) IN VALET MODE ON/OFF:
If this feature is turned on, the ground-when-
armed output will be active when the doors are locked with the transmitter whenever the system is in valet mode.
This can enable the starter kill relay, even in valet mode.
