Dinolift DINO XT II 160, Руководство по эксплуатации

Страница: 41 / 73

41
B) XT OPTION: POWERED BY COMBUSTION ENGINE, PETROL
• do not connect the power supply cable (230 VAC)
• Open the fuel cock
• As required, switch on the choke for the start by pushing the choke
button.
1 2
3 4
• Start the engine via the rotary switch
1 2
3 4
If the battery is flat:
• Ensure that the key switch Q1 is in the position UCB.
• Keep the button on the bed of the petrol-driven power pack
depressed, and simultaneously, pull the starter string. Pull the starter
string lightly until you feel resistance, then pull briskly.
• Keep the button depressed for about 1 minute in order to recharge
the battery.
• Do not allow the starter grip to snap back against the engine.
Piirustuksen numero
VILAKONE OY
Tulostus pvm.
Revisio
Kpl/kone
Ohjetarra, joystick
1
41603606
• Turn off the motor via the rotary switch after the use.
1 2
3 4
NOTE! When you stop using the combustion engine, close the fuel
cock. The fuel cock must be closed during towing of the lift.
C) XT OPTION: POWERED BY COMBUSTION ENGINE, DIESEL
• Do not connect the power supply cable (230 VAC)
• Start the engine via the rotary switch
1 2
3 4
Refer to the separate user manual for the diesel engine for instructions
about starting up the engine, when the battery is flat.
• Turn off the motor via the rotary switch after the use.
1 2
3 4
NOTE! To avoid damaging the electronics of the diesel engine, do not
disconnect the main current while the diesel engine is running!
Leave the combustion engine running also between the operations, because
the battery will not be recharged, unless the combustion engine is running.
The electric timer of the lift automatically disconnects the supply voltage (12 VDC) in about 1
hour after the electric motor or the combustion engine has been turned off.
To re-activate the voltage supply, turn the speed selector switch (in LCB) or depress the
activation switch at the control lever (in UCB).