Dinolift DINO XT II 160, Руководство по эксплуатации

Страница: 44 / 73

44
Operating instructions • DINO 160XTB II • 180XTB II • 210XTB II
5.2.2. Operating the lift from the platform control centre
Risk of falling!
Wear a safety harness while on the platform, and
fix it to the point marked for it.
Make sure that the platform gate remains closed during the
operation.
DANGER
WARNING
CAUTION
NOTICE
1. Turn the selector switch to the position UCB, and remove the key. Close the
protective cover for the chassis control centre
Piirustuksen numero
VILAKONE OY
Tulostus pvm.
Revisio
Kpl/kone
Ohjetarra, joystick
1
41603606
2. Step onto the platform and fix the safety harness to the attachment point
intended for it.
3. Operate the boom movements using the control lever .
To operate the movements of the boom system, press first the rocker switch at the end of the
control lever, and after that, move the control lever carefully in the desired direction of movement
of the boom. The movement speed can be adjusted steplessly.
If you move the lever before pressing the rocker switch, the action will be deterred.
4CB2106
Activation button –
Operating direction
of the lever
Movement Symbol
JSL - up/down Boom up/down
JSL - to the left / right
Turning the boom clockwise/
counter-clockwise
JSR - up/down
Retracting/extending the
telescope
JSR - to the left / right Articulated arms down/up
Always try to keep the boom short during the lifting and lowering movements.
4. Operate the platform movements using the lever switches.
Push the activation switch for the platform movements, and keep it depressed
throughout the movement.
1 2
3 4
Select the movement and its direction using the lever switches
1 2
3 4
1 2
3 4
1 2
3 4
As required, see the point ”Operating controls in the platform control centre” for more
information.
DANGER
WARNING
CAUTION
NOTICE
Never add load onto the platform, while the red overload light is illuminated. Tip over
hazard!
Measures to be taken after an event of overloading:
Retract the platform to inside the operating range of the RK4 by pressing the “telescope in”
button (the green light will be illuminated). After this, the lift may be operated normally.