Dinolift DINO XT II 160, Руководство по эксплуатации

Страница: 56 / 73

56
Operating instructions • DINO 160XTB II • 180XTB II • 210XTB II
6. INSTRUCTIONS FOR FAULT-FINDING
FAULT REMEDY
1. The electric motor does not start from its start button or if any of the movements is
activated
The correct operating location has not been
selected.
Select the correct operating location using the key
switch Q1.
Main switch has been turned off. Switch on the main switch.
The emergency stop button either in the chassis
or the platform control centre has jammed in the
lower position.
Pull up the button and re-start the motor.
No power supply to the main centre – no reading
in the battery gauge.
Check the fuse F3 (main centre, 10A glass tube).
Check the fuse F12 (left battery housing, 15A car
fuse).
Check the fuse FG (left battery housing, 150A
mega fuse).
Power supply to the main centre is OK – reading
in the battery gauge between 100 % and 1 %.
Check the fuse F1 (main centre, 10A glass tube).
Check the fuse F4 (main centre, 10A glass tube).
Power supply to the main centre is OK – reading
in the battery gauge is 0 %.
Batteries are flat –> recharge the batteries by
connecting the mains cable.
2. Movements "boom up" and "telescope out" are not operational, even though the
electric motor starts normally when other movements are being actuated.
Low battery voltage, lifting movements are
impeded.
Recharge the batteries by connecting the mains
cable.
3. None of the platform movements is operational though the electric motor is running
and the selector switch is in the correct position
The lift has been overloaded.
Reduce the platform load
or
Retract the telescope until the platform
returns inside its operating range (the
green light in the platform control centre
lights up).
1 2
3 4
6. Outriggers do not move
Boom is not resting on the transport support. Drive the boom onto the transport support.
The selector switch is in the wrong position.
Turn the selector switch to the correct
position.
Piirustuksen numero
VILAKONE OY
Tulostus pvm.
Revisio
Kpl/kone
Ohjetarra, joystick
1
41603606
The limit switch on the boom support has not
closed.
Drive the boom onto the transport support.