Dinolift DINO XT II 160, Руководство по эксплуатации

Страница: 40 / 73

40
Operating instructions • DINO 160XTB II • 180XTB II • 210XTB II
5.1.3. Starting up
1. If necessary, connect the power supply cable to mains current. With the
electric motor at maximum load, the voltage must be 230 VAC (-10%/
+6%), the frequency 50 Hz, and rating of the fuse 10A (the length of the
connecting cable has some effect)
2. Switch on the main current
ON
3. To access the operating controls, open the cover of LCB centre on the
turning device.
4. Select the control centre (LCB/UCB) using the selector switch.
5. Turn on the operating voltage
• in the LCB centre: by turning the speed selector switch
• in the UCB centre: by pressing the activation switch at the end of
the control lever
After this, the start-stop automatics will start and stop the electric motor
whenever any of the movements is activated.
The engine will stop automatically as soon as the movement stops.
NOTE! If you wish to operate the support outriggers, start the electric motor by pushing the
green start button at the control centre for the outriggers. The electric motor will keep on
running until the button is released.
Ensure that the batteries remain sufficiently charged during the workday!
A ) XT: POWERED BY ELECTRIC MOTOR
• If you want to keep the electric power unit constantly running (e.g. if
the weather is cold), start the electric motor using the rotary switch.
This will bypass the start-stop automatics.
1 2
3 4