Nexus Manual 022012 | 49
1
2
3
5
6
2.9.5 PTZ ADDRESS SETTINGS
Some protocols support software address settings. The RX Address and ID
settings are compatible with a particular line of receivers that support 2 ID
addresses. The PT Driver Address is associated with the PTZ ID address set
on the camera. The addresses must match for the NVR to communicate with
the proper PTZ camera. This is especially important when a large number of
PTZ cameras are connected to the NVR.
Note: To select a PT Driver Address of 129-254, manually enter the ID in the
box.
2.9.6 ACCESSING THE PTZ MENUS
Some protocols support the ability to access the Internal PTZ Onscreen menu. Since every PTZ camera is different, the functions of these
options can vary slightly. The NVR provides an easy way to access the camera’s options.
For explanations on those camera options, please refer to your camera manual.
Note: Use the arrow buttons on the PTZ Controller to move through the PTZ Menu
options or highlight the options.
1.
X Button
Close the PTZ remote controller.
2.
Arrows
Use the arrow buttons to move the
camera left, right, up, or down.
3.
CH number
The number in the center of the
controller represents the channel
number you are currently attempting to
control.
4.
Zoom, Focus, Iris
Increase/decrease the camera’s zoom,
or adjust focus and iris remotely.
5.
Wiper, Light, Tour
Enable/Disable the camera’s Wiper,
Light and Tour.
6.
Presets
Select a preset to move the camera to
that set location.
4
