Digital Equipment DLE49-MA, Руководство пользователя

Страница: 71 / 216

Management Terminal Setup
DLE49-MA User’s Guide 5-7
For information about setting the IP address, refer to Section 5.8 .
For information about assigning community names, refer to Section 5.9 .
Refer to the instructions included with the Telnet application for
information about establishing a Telnet session.
If the DLE49-MA is operating in the 802.1Q mode, the host interface
must be on the same VLAN as the physical port that the management
station is connected to. Refer to the DIGITAL MultiSwitch 700 802.1Q
VLAN User’s Guide for information about VLANs.
5.3.4 Monitoring an Uninterruptible Power Supply
If the DLM6C-AA chassis is connected to an American Power
Conversion (APC) Uninterruptible Power Supply (UPS) for protection
from a loss of power, a connection from the COM port of a module to the
UPS can be made to monitor the status of the UPS. To use the COM port
for this purpose, it must be reconfigured to support the UPS application.
This procedure is performed from the General Configuration screen of the
interface module.
Section 6.5.11 provides detailed instructions on
configuring the COM port for UPS applications. Refer to the UPS
documentation for details on how to access the status information.
Use the Console Cable Kit provided with the DLM6C-AA chassis to
attach the UPS to the module COM port as shown in
Figure 5-2 .
Connect the UPS device to the COM port of the DLE49-MA as follows:
1. Connect the RJ45 connector at one end of the cable to the COM port
on the module.
2. Plug the RJ45 connector at the other end of the cable into the
RJ45-to-DB9 male (UPS) adapter, Cabletron Systems
Part No. 9372066.
3. Connect the RJ45-to-DB9 male (UPS) adapter to the female DB9 port
on the rear of the UPS device (refer to the particular UPS device’s user
instructions for more specific information about the monitoring
connection).