Digital Equipment DLE49-MA, Руководство пользователя

Страница: 117 / 216

General Configuration Screen
DLE49-MA User’s Guide 6-11
then replaced with DLE49-MA default configuration settings. For details,
refer to
Section 6.5.12 .
IP Fragmentation (Toggle)
Used to enable or disable IP Fragmentation. The default setting for this
field is ENABLED. If the DLE49-MA will be bridged to an FDDI ring, IP
Fragmentation should be enabled. If IP Fragmentation is disabled, all
FDDI frames that exceed the maximum Ethernet frame size will be
discarded. For details on enabling or disabling IP Fragmentation, refer to
Section 6.5.13 .
6.5.1 Setting the IP Address
To set the IP address, perform the following steps:
1. Use the arrow keys to highlight the IP Address field.
2. Enter the IP address into this field using Decimal Dotted Notation
(DDN) format (xxx.xxx.xxx.xxx).
3. Press ENTER. If the IP address is a valid format, the cursor returns to
the beginning of the IP address field. If the entry is not valid, the Event
Message Line displays “INVALID IP ADDRESS OR FORMAT
ENTERED”. Local Management does not alter the current value and
refreshes the IP address field with the previous value.
4. Use the arrow keys to highlight the SAVE command, then press
ENTER. The warning screen shown in
Figure 6-6 displays.
If the DLM6C-AA chassis has been assigned an IP address, it
is not necessary to assign an IP address to the DLE49-MA. All
installed modules have the same IP address as the chassis. If
a separate IP address for the module is desired, proceed as
follows.