Digi IX20, Руководство пользователя

Страница: 584 / 726

System administration Reset the device to factory defaults
IX20 User Guide 584
Depending on your device configuration, you may be presented with an Access selection
menu . Type admin to access the Admin CLI.
2. Enter the following:
> system factory-erase
3. After resetting the device:
a. Connect to the IX20 by using the serial port or by using an Ethernet cable to connect the
IX20 ETH2 port to your PC.
b. Log into the IX20:
User name : Use the default user name: admin .
Password : Use the unique password printed on the bottom label of the device (or the
printed label included in the package).
When you first log into the WebUI or the command line, you must change the password for
the
admin user. See Change the default password for the admin user for instructions.
Additionally, for Wi-Fi enabled models, when you first log into the WebUI or the command
line, you will be required the change the SSID and pre-shared key (password) for the
preconfigured Wi-Fi access point. See
Reset default SSID and pre-shared key for the
preconfigured Wi-Fi access point for instructions.
c. Reset the default password for the admin account. See Change the default password for
the admin user for further information.
Reset the device by using the ERASE button.
1. Locate the ERASE button on your device.
2. Press and hold the ERASE button perform a device reset. The ERASE button has two modes:
n
Configuration reset :
l
Press and release the ERASE button.
l
The device reboots automatically and resets to factory defaults. This does not
remove any automatically generated certificates and keys.
n
Full device reset :
l
After the device reboots from the first button press, immediately press and release
the
ERASE button again.