Digi IX20, Руководство пользователя

Страница: 170 / 726

Wi-Fi Configure the Wi-Fi radio's transmit power
IX20 User Guide 170
1. Log into the IX20 command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu . Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Set channel for the radio:
a. Set the band for the radio:
(config)> network wifi radio phy0 band value
(config)>
where value is either 2400mhz or 5000mhz .
b. Set the mode for the Wi-Fi radio. For example:
n
If the Wi-Fi radio has a band of 2400mhz :
(config)> network wifi radio phy0 2400mhz mode value
(config)>
where value is one of b , bg , bgn , g , gn , or n .
n
If the Wi-Fi radio has a band of 5000mhz :
(config)> network wifi radio phy0 5000mhz mode value
(config)>
where value is one of ac , acn , or n .
4. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
5. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu . Type quit to disconnect from the device.
Configure the Wi-Fi radio's transmit power
The default Wi-Fi transmit power that the Wi-Fi radio will use when in access point or client mode is
100 percent. You can configure the Wi-Fi radio to transmit at a lower power.

WebUI