DH Instruments ADCS-601-AF, Руководство по эксплуатации и обслуживанию

Страница: 110 / 174

ADCS-601-AF™ OPERATION AND MAINTENANCE MANUAL
© 2005 - 2007 DH Instruments, a Fluke Company Page 98
To run the validation test proceed as follows:
Turn OFF the model 3682, open the console door and set the
RUN / CAL / DIAG switch to CAL . Turn the model 3682 back ON and allow
one hour warm up to complete.
Set the model 3682 to <Calibration Manual > mode on the front panel:
•
Press [Advance]
•
Press [Calibration Manual]
•
Press [Advance]
•
Select [Standardization]
•
Select [PS] or [PT]
•
Press [Advance]
•
Press [Advance]
Set the ADCS-601-AF to absolute measurement mode using the [MODE]
button on the ADCS Tools Main Run Screen .
Vent the ADCS-601-AF using the [VENT] button on the ADCS Tools Main
Run Screen .
Enter the appropriate <Upper Limit> value on the ADCS Run Screen . Enter
32 inHg when calibrating the Ps transducer and 110 inHg when calibrating
the Pt transducer.
Connect the ADCS-601-AF TEST(+) port to the 3682 Ps or Pt port.
Select [Run][Run Test Definition] in ADCS Tools .
Select <inHg> as the unit of measure and press [Next] . If the same test was
previously run with the same instrument and pressure range, press [Finish]
to automatically use the previous settings.
In the <Selected DUTs> panel, do NOT select a DUT. If any DUT is
selected, remove it by clicking on it and pressing the [Remove] button.
Press [Next] when ready.