68
2. Installation and Setup
3. Performing the Initial Work
Step 2 : Automatic Correction
Required Tools
Included items
Rotary axis correction jig
ATC magazine correction jig/
A screw
Detection pin for correction
Cloth for care and
maintenance
Important
Handle the detection pin for correction and the dummy pin separately to be absolutely sure that
you do not confuse them.
If the detection pin for correction is used as the dummy pin even once, the detection pin for correction cannot be
used to provide proper correction. If for some reason the detection pin for correction is used as the dummy pin,
a new detection pin for correction will be necessary. Contact your authorized DGSHAPE Corporation dealer or
access our website (http://www.dgshape.com/).
1.
Clean the detection point for use during correction.
A
Open the front cover.
B
Remove all milling burs that have been set.
MEMO When the milling bur is difficult to remove (using the milling bur removal jig)
When the milling bur is difficult to remove, you can remove it easily by using the milling bur removal jig.
Insert the tip of the milling bur into the tip (the narrow end) of the milling bur removal jig, and then
push the milling bur up.
CAUTION
Caution: Be careful around the tip and other sharp edges.
Doing so may cause injury.
