64
2. Installation and Setup
3. Performing the Initial Work
C
Check the tightening of the coolant tank cap.
D
Make the coolant.
To make the coolant, mix the water, additive (ZAW-1000D), and chelating reagent (ZCH-100D) at fixed
ratios. Use the included measuring cup for measuring.
1
Mix water and additive in the ratio of “95:5” (water:additive).
There is no need to stir the solution.
The capacity of the coolant tank is approximately 5 L. To fill the tank, use 4,750 ml of water and 250 ml of
additive.
2
Mix the water + additive solution and chelating reagent in the ratio of “400:1” (water +
additive solution:chelating reagent).
There is no need to stir the solution.
To fill the tank, use 5,000 ml of water + additive solution and 12.5 ml of chelating reagent.
Water:additive = 95:5
* * When filling the tank: water = 4,750 ml and additive = 250 ml
Water + additive solution:chelating reagent = 400:1
* * When filling the tank: water + additive solution = 5,000 ml and
chelating reagent = 12.5 ml
CAUTION
Be sure to use the specified additive.
Additives are effective in reducing coolant deterioration and raising the milling
efficiency in order to maintain product performance. Furthermore, if additives are
not used, the coolant may generate an unpleasant odor.
CAUTION
Be sure to use the specified chelating reagent.
The chelating reagent works to make calcium and similar substances contained
in the water inactive, making it easier to clean off milling powder that adheres to
the machine and the cutting tool after milling.
Refer to the appropriate safety data sheet (SDS) for the chemical substances used in the additive and
chelating reagent and the safety related to those substances.
To purchase additives, contact your authorized DGSHAPE Corporation dealer or access our website
(http://www.dgshape.com/).
