Desoutter CVIL II, Руководство оператора, Страница: 25 / 80

01/2018 25 / 80
6159933780
Issue no: 09
CVIL II
Parameter Comment
Stall time
0.000 - 9.990 seconds.
Other...
See motor parameters
Detailed RP: See "Tightening strategy guide",
page 60.
7.3.5.4 - Action on NOK Phase
(Normal mode and Pulse mode)
When a report is rejected (max. torque or angle
reached, etc.), it is possible to apply a specific corrective
action to the cycle, either by stopping the cycle or by
programming a corrective phase.
For example: untighten the screw, repeat tightening, etc.
You must first choose:
● The fault(s) to which you want to apply a corrective
action.
● The number of tests (from 1 to 99).
Various actions on NOK are available:
Parameter Comment
End To stop the tightening cycle.
Rrv.+End A Run Reverse phase is run according
to the programmed time then the cycle
is stopped.
Jump The cycle proceeds to the indicated
phase.
Rrv.+Jump
A run reverse phase is run according
to the programmed time, then the
cycle proceeds to the indicated phase.
Thread Right / Left.
Rv time Run reverse time: 0 - 99 s
No phase RP.
7.3.5.5 - Run reverse phase
(Normal mode and Pulse mode)
Parameter Comment
Max.time Phase running time out: 0.01 - 99 s.
Int.time Time programmed between this phase
and the next one: 0 - 20 s.
Strategy Torque/Angle/Angle+Torque.
Min T Minimum torque: 0 Nm to maximum
value of the spindle.
Target T
Target torque: 0 Nm to maximum value
of the spindle (torque or angle
strategy).
Max T Maximum torque: 0 Nm to maximum
value of the spindle.
Safety T Safety torque: 0 Nm to maximum value
of the spindle.
B-away T Breakaway torque: starts the torque
control (strategies: torque or torque
+ angle), must be higher than final
torque.
Threshol Angle threshold: 0 Nm to maximum
value of the spindle.
Min A Minimum angle: 0 - 9,999°.
Target A Target angle: 0 - 9,999°
(angle + torque strategy).
Max A Maximum angle: 0 - 9,999°.
Other... See motor parameters.
Detailed RP: See "Tightening strategy guide",
page 60.