Desin Instruments HS-7000 Series, Общее руководство по инструкции

Страница: 73 / 108

73
CONFIGURATION OF THE MAIN PARAMETERS OF THE INPUT AI 3 (AI S ON DISPLAY)
● Input type:
- In [ConF] [AI S] in parameter [P 02] modify the digit “n” in [???n]
- Select [???n] between 0 (no service), 1 (0-20 mA), 2 (4-20 mA)
- Go to the next parameter using or or press to exit.
●
Number of decimals:
- In [ConF] [AI S] in parameter [P 02] modify the digit “n” in [??n?]
- Select [P 02] [??n?] between 0 (no decimals), 1 (000.0), 2 (00.00), 3 (0.000) according
to the required number of decimals.
- Go to the next parameter using or or press to exit.
Examples of the codes to enter in [AI S] [P 02] depending on the models: [P 02]
- Input 4-20 mA without decimals [0002]
- Input 4-20 mA with 1 decimal [0012]
- Input 4-20 mA with 2 decimals [0022]
- Input 0-20 mA without decimals [0001]
- Input 0-20 mA with 3 decimals [0031]
●
Reading limit Indication:
- In [ConF] [AI S] in parameter [P 03] modify the digit “n” in [???n]
- Set [P 03] to [???1] so that the display shows Unde when the input signal goes under
the range low limit, or Over if the input signal goes over the range high limit.
Note: The range low and high limits are defined in [P 04] y [P 05], or by the range associated
to a mA input.
- Set [P 03] to [???0] so that the dispaly keep indicating the measurement even if the input
signal value exceeds the range limits.
- Go to the next parameter using or or press to exit.
Examples:
- Set [???1] ... for a range of -100 t 100 (4-20 mA) if the input signal exceeds (3 ... 21
mA) the display will show Unde and Over
- Set [???0] ... for a range of -100 a 100 (4-20 mA) for 3 ..or.. 21 mA the display
indicates the proportional reading.
Not
used
0...0000
1...000.0
2...00.00
3...0.000
0...No
1...0-20 mA
2...4-20 mA
Not
used