Delta Tau Geo MACRO, Руководство пользователя и справочное руководство

Страница: 35 / 205

Geo MACRO Drive User and Reference Manual
Connections 23
Wiring AC Input, J1
The main bus voltage supply is brought to the Geo drive through connector J1. 1.5A continuous and 3A
continuous Geo drives can be run off single-phase power. It is acceptable to bring the single-phase power
into any two of the three input pins on connector J1. Higher-power drive amplifiers require three-phase
input power. It is extremely important to provide fuse protection or overload protection to the input
power to the Geo drive amplifier. Typically, this is provided with fuses designed to be slow acting, such
as FRN-type fuses. Due to the various regulations of local codes, NEC codes, UL and CE requirements,
it is very important to reference these requirements before making a determination of how the input power
is wired.
Additionally, many systems require that the power be able to be turned on and off in the cabinet. It is
typical that the AC power is run through some kind of main control contact within the cabinet, through
the fuses, and then fed to a Geo drive. If multiple Geo drives are used, it is important that each drive has
its own separate fuse block.
Whether single- or three-phase, it is important that the AC input wires be twisted together to eliminate
noise radiation as much as possible. Additionally, some applications may have further agency noise
reduction requirements that require that these lines be fed from an input filtering network.
The AC connections from the fuse block to the Geo drive are made via a cable that is either purchased as
an option from Delta Tau (CABKITxx) or made with the appropriate connector kit (CONKITxx).
(Appendix A)
J1: AC Input Connector Pinout
Pin # Symbol Function Description Notes
1 L3 Input Line Input Phase 3
2 L2 Input Line Input Phase 2
3 L1 Input Line Input Phase 1 (not used for single Phase Input)
On Gxx201xx and Gxx301xx, there is a fourth pin for Ground connection.
If DC bus is used, use L3 for DC+ and L2 for DC return.
Connector is located at the bottom side of the unit.
Wiring Earth-Ground
Panel wiring requires that a central earth-ground location be installed at one part of the panel. This
electrical ground connection allows for each device within the enclosure to have a separate wire brought
back to the central wire location. Usually, the ground connection is a copper plate directly bonded to the
back panel or a copper strip with multiple screw locations. The Geo drive is brought to the earth-ground
via a wire connected to the M4 stud (5mm thread) on the top of the location through a heavy gauge,
multi-strand conductor to the central earth-ground location. On some models, a fourth pin is provided on
the 3-phase AC input connector (J1) and on the motor output connectors to provide a ground connection.
Earth Grounding Paths
High-frequency noises from the PWM controlled power stage will find a path back to the drive. It is best
that the path for the high-frequency noises be controlled by careful installation practices. The major
failure in problematic installations is the failure to recognize that wire conductors have impedances at
high frequencies. What reads 0 ohms on a handheld meter may be hundreds of ohms at 30MHz.
Consider the following during installation planning:
1. Star point all ground connections. Each device wired to earth ground should have its own conductor
brought directly back to the central earth ground plate.
2. Use unpainted back panels. This allows a wide area of contact for all metallic surfaces reducing high
frequency impedances.
3. Conductors made up of many strands of fine conducts outperform solid or conductors with few
strands at high frequencies.