Delta Tau Geo MACRO, Руководство пользователя и справочное руководство

Страница: 204 / 205

Geo MACRO Drive User Manual
192 Appendix D
Ixx79 Ixx29 Electrical
Cycle U V W
Positive
3000 -1500 -30 0 1 0
1500 -3000 -90 1 1 0
-1500 -1500 -150 1 0 0
-3000 1500 150 1 0 1
-1500 3000 90 0 0 1
1500 1500 30 0 1 1
3000 -1500 -30 0 1 0
The HEZ occurs at 60
°
electrical. If the
transition of V from 0 to 1 at the HEZ point
is in the negative direction (like this
example), then the hall effect sensing would
be considered reversed. If the transition of V
from 0 to 1 at the HEZ is in the positive
direction, then the hall effect sensing would
be considered standard.
Positive refers to the direction of the
electrical cycle.
The description of Ixx91 in the Software Reference manual shows the common values of offsets used, for
all the cases where the zero point in the hall-effect cycle is at a 0
o
, 60
o
, 120
o
, 180
o
, -120
o
, or -60
o
point --
where manufacturers generally align the sensors.
Ixx81 Hall Effect phase settings are described in the Turbo Software manual.
Ixx91 Hall Effect Setup for Turbo PMAC2
Hex ($)
Bit
Value
C B
23 22 21 20
1 1 0 0
19
1
18
0
17 16
1 1
Reserved
0 0 0
14 13 12 15
0 0 0 0
10 9 8 11
0 0 0 0
6 5 4 7
0 0 0 0
2 1 0 3
0 0 0 0
0
Hall Effect Offset ($0B)
Standard Hall Sense (0), Reversed Hall Sense (1)
Hall Effect Type Phase (1)
Ixx91 mask = $80 + $40 + $0B = $CB
For Turbo PMAC2 axis #1, this would give us
I191 = $CB0000
Example 2 of Hall Effect Values
Rough phasing routines Based on Tests Results
OPEN PLC 11 CLEAR
IF(M128&7=6)
M171=330/360*I171
ELSE
IF(M128&7=2)
M171=270/360*I171
ELSE
IF(M128&7=3)
M171=210/360*I171
ELSE
IF(M128&7=1)
M171=150/360*I171
ELSE
IF(M128&7=5)
M171=90/360*I171
ELSE
M171=30/360*I171
ENDI
ENDI
ENDI
ENDI
ENDI
DISPLC11
CLOSE