Dell Force10 Z9000, Справочное руководство

Страница: 1452 / 1483

M Gi 13/5
FTOS#
vlan-stack dot1p-mapping
Map C-Tag dot1p values to a S-Tag dot1p value. C-Tag values may be separated by commas and dashed ranges are
permitted. Dynamic mode CoS overrides any Layer 2 QoS configuration in case of conflicts.
C-Series, S-Series, Z-Series, S4810
Syntax vlan-stack dot1p-mapping c-tag-dot1p values sp-tag-dot1p value
Parameters
c-tag-dot1p
value
Enter the keyword
c-tag-dot1p
followed by the customer dot1p
value that will be mapped to a service provider do1p value. The range
is 0 to 7.
sp-tag-dot1p
value
Enter the keyword
sp-tag-dot1p
followed by the service provider
dot1p value. The range is 0 to 7.
Defaults none
Command Modes INTERFACE
Command History
Version 8.3.7.0 Introduced on the S4810.
Version 8.3.1.0 Introduced on the C-Series and S-Series.
vlan-stack protocol-type
Define the stackable VLAN tag protocol identifier (TPID) for the outer VLAN tag (also called the VMAN tag). If you do not
configure this command, FTOS assigns the value 0x9100.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax vlan-stack protocol-type number
Parameters
number
Enter the hexadecimal number as the stackable VLAN tag.
• On the E-Series: FTOS accepts the most significant byte
(MSB) and then appends zeros for the least significant byte
(LSB). The range is 0 to FF.
• On the C-Series and S-Series: You may specify both bytes of
the 2-byte S-Tag TPID. The range is 0 to FFFF. The default is
9100.
1452