Dell Force10 Z9000, Справочное руководство

Страница: 1021 / 1483

ip multicast-limit
Use this feature to limit the number of multicast entries on the system.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax ip multicast-limit limit
Parameters
limit Enter the desired maximum number of multicast entries on the
system. The E-Series range is 50000, the C-Series range is 1 to 10000,
and the S-Series range is 1 to 2000.
Defaults
• E-Series Default: 15000.
• C-Series Default: 4000.
• S-Series Default: 400.
Command Modes CONFIGURATION
Command History
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced on the C-Series.
Version 7.6.1.0 Introduced on the E-Series.
Usage
Information This features allows you to limit the number of multicast entries on the system. This number is
the sum total of all the multicast entries on all line cards in the system. On each line card, the
multicast module only installs the maximum possible number of entries, depending on the
configured CAM profile.
Use the IN-L3-McastFib CAM partition to store multicast routes. It is a separate hardware limit
that exists per port-pipe. Any software-configured limit might be superseded by this hardware
space limitation. The opposite is also true, the CAM partition might not be exhausted at the
time the system-wide route limit set by the
ip multicast-limit
command is reached.
Related
Commands show ip igmp groups – shows the IGMP groups.
show ipv6 mroute
View IPv6 multicast routes.
E-Series
Syntax show ipv6 mroute [ group-address [ source-address ]] [active rate ]
[count group-address [source source-address ]]
1021