![background image](http://html.mh-extra.com/html/datacard/sr200/sr200_user-manual_511393069.webp)
SR200 & SR300 Printer User Guide
65
HR Overheat
The retransfer or bend
remedy roller is too hot.
Turn the power switch off and then on again. Call for
service if the problem persists.
TR Heater
The retransfer roller is not
working.
Turn the power switch off and then on again. Call for
service if the problem persists.
TR Overheat
The retransfer roller is too
hot.
Turn the power switch off and then on again. Call for
service if the problem persists.
TR Thermister
The retransfer roller
thermistor is not working.
Turn the power switch off and then on again. Call for
service if the problem persists.
RR Overheat
The bend remedy roller is
too hot.
Turn the power switch off and then on again. Call for
service if the problem persists.
RR Heater
The bend remedy roller is
not working.
Turn the power switch off and then on again. Call for
service if the problem persists.
RR Thermister
The bend remedy roller
thermistor is not working.
Turn the power switch off and then on again. Call for
service if the problem persists.
Overcool
It is too cold for the printer
to operate.
The temperature in the printer area is too low. Use at
the recommended operating environment temperature
as described in
“Operating environment” on
page 72
.
Head Overheat
The thermal head is
overheated.
Turn the power switch off and allow the printer to cool
for approximately 10 minutes before turning power
back on.
Power Intrpt
Power was interrupted for
a short time.
Turn the power switch off and then on again. Call for
service if the problem persists.
EEProm Broken
EEPROM malfunction
Turn the power switch off and then on again. Call for
service if the problem persists.
MG Unconnected
Magnetic stripe module
connection error
Turn the power switch off and then on again. Call for
service if the problem persists.
MG Mechanical
Magnetic stripe
mechanical error
Turn the power switch off and then on again. Call for
service if the problem persists.
MG Hardware
Magnetic stripe hardware
error
Turn the power switch off and then on again. Call for
service if the problem persists.
MG Test Err
A write error occurred
during self-test.
1 Check the type and orientation of magnetic cards in
the card hopper as described in
“Load cards” on
page 8
.
2 Press Reset, and then Return to initialize the
printer.
LCD Message
Possible Cause
Solution
Содержание SR200
