DataCard SR200, Руководство пользователя

Страница: 15 / 85

SR200 & SR300 Printer User Guide 11
Load retransfer film
1 Slide the door latch up and
open the printer door.
2
Press the retransfer film
cartridge eject button and
remove the green cartridge.
3
Remove both used film
spools from the cartridge (if
present).
4
Load the new roll of retransfer
film on the cartridge:
a Put the full roll of film on
the green supply spindle
as shown (A).
b Put the empty take-up
spool on the black take-up
spindle (B).
c
Align the retransfer film
along the three film
guides.
d
Wind two frames of film
onto the take-up spool.
e Take up slack by turning
the take-up knob
clockwise. Gently pull
the take-up knob and
turn. If slack cannot be
removed, check that the
supply and take-up
spools are firmly seated
on the spindles.
To ease inserting into
the printer, the film must be
tight along the film guides.
Turning the supply and
take-up knobs will help
maintain the proper tension.
5
Replace the loaded retransfer
film cartridge in the printer until
it clicks into position.
6
Close the printer door.
Tips: Handling retransfer film
• Place the cartridge on a
smooth level surface when
loading or reloading.
•
Do not touch the printing
surface of the retransfer
film. (Oils on hands will
reduce printing quality.)
•
Always initialize the
retransfer film after
powering on the printer.
See
“Initialize the ink ribbon
and retransfer film” on
page 14
for more
information.
•
Keep unused film in the
original package.
• Do not place film on a dusty
or dirty surface — dirt can
affect print quality.
•
When the retransfer film
has run out, “Media Run
Out” appears on the LCD
panel. After replacing it,
press the Reset key and
then the Enter key to
initialize the film.
•
The retransfer film cartridge
cannot be replaced in a
printer that is in Transport
Mode. Power the printer on
to cancel Transport Mode.
• See “Retransfer film” on
page 68 for more
information about retransfer
film.