10.2.3 Power Card Mounting Plate
The power card can remain attached when the power card mounting plate is removed from the drive. To remove the power
card mounting plate with the card attached, use the following steps. Refer to
.
To remove the power card from the plate, refer to
.
The IP20 enclosure has a different type and number of fasteners.
Disassembly
1.
Remove the control card mounting plate. Refer to
chapter 10.2.2 Control Card and Control Card
Mounting Plate
2.
Unplug the following power card connectors:
2a
MK101
2b
MK103
2c
MK501
2d
MK502
2e
MK902
2f
Any wiring at MK500 and MK 106
3.
Remove 4 screws (T20), 1 from each corner of the
mounting plate.
4.
Remove 1 screw (T25) from the top center of the
mounting plate.
5.
Free the cables from the retaining clips on the
plate.
6.
Lift the power card mounting plate from the
drive.
Reassembly
Tighten hardware according to
.
1.
Position the power card mounting plate in the
drive.
2.
Secure 1 screw (T25) in the top center of the
mounting plate.
3.
Secure 4 screws (T20), 1 in each corner of the
mounting plate.
4.
Attach the following power card connectors:
4a
MK101
4b
MK103
4c
MK501
4d
MK502
4e
MK902
4f
Any wiring at MK500 and MK106
5.
Route the cables through the retaining clips.
6.
Replace the control card mounting plate. Refer to
chapter 10.2.2 Control Card and Control Card
Mounting Plate
.
D1h/D3h/D5h/D6h/J8 Drive Di...
VLT
®
FC Series, D1h–D8h, Da2/Db2/Da4/Db4, E1h–E4h, J8/J9
132
Danfoss A/S © 02/2019 All rights reserved.
MG94A502
10
10
Содержание VLT FC Series
Страница 2: ......
Страница 369: ...Index Service Guide MG94A502 Danfoss A S 02 2019 All rights reserved 367...