Danfoss VLT AAF00x, Инструкция по эксплуатации, Страница: 109 / 117

No. Description Warning Alarm/Trip Alarm/Trip Lock Parameter Reference
39 Heatsink sensor X X
40 Overload of Digital Output Terminal 27 (X) 5-00, 5-01
41 Overload of Digital Output Terminal 29 (X) 5-00, 5-02
46 Pwr. card supply X X
47 24 V supply low X X X
48 1.8 V supply low X X
65 Control Board Over-temperature X X X
66 Heat sink Temperature Low X
67 Option Configuration has Changed X
68 Safe Stop Activated
X 1)
69 Pwr. Card Temp X X
70 Illegal FC configuration X
72 Dangerous Failure
X 1)
73 Safe Stop Auto Restart
76 Power Unit Set-up X
79 Illegal PS config X X
80 Drive Initialized to Default Value X
244 Heatsink temp X X X
245 Heatsink sensor X X
246 Pwr.card supply X X
247 Pwr.card temp X X
248 Illegal PS config X X
250 New spare part X
251 New type code X X
300 Line Power Cont. fault X
301 SC Cont. Fault X
302 Cap. Overcurrent X X
303 Cap. Earth Fault X X
304 DC Overcurrent X X
305 Line Power Freq. Limit X
308 Resistor temp X X
309 Line Power Ground Fault X X
311 Switch. Freq. Limit X
314 Auto CT Interrupt X
315 Auto CT Error X
316 CT Location Error X
317 CT Polarity Error X
318 CT Ratio Error X
Table 9.1 Alarm/Warning code list
A trip is the action when an alarm has appeared. The trip
will stop the filter operation and can be reset by pressing
the reset button or make a reset by a digital input (Par.
5-1* [1]). The origin event that caused an alarm cannot
damage the filter or cause dangerous conditions. A trip
lock is an action when an alarm occurs, which may cause
damage to the device or connected parts. A trip lock
situation can only be reset by power cycling.
LED indication
Warning yellow
Alarm flashing red
Trip locked yellow and red
Troubleshooting VLT Active Filter AAF 00x
9-2 MG.90.V2.22 - VLT
®
is a registered Danfoss trademark
9 9