Daikin SUT06S3016-30, Руководство по эксплуатации

Страница: 74 / 99

PIM00413
12-10
Pressure
Change Time
PQ0：Pressure in high pressure side
Time
PQ1：Acceleration time
1MPa
1MPa
Flow Rate
Change Time
Time
1000min-1
1000min-1
◆Pressure and flow rate change time when the PQ selection switches
PQ Selection
Number
PQ0 PQ1 PQ0
P
r
e
s
s
u
r
e
F
l
o
w
R
a
t
e
PQ1：Pressure in
high pressure side
PQ0：Deceleration time
PQ0：Pressure in high pressure side
PQ0：Flow rate in high pressure side PQ0：Flow rate in high pressure side
PQ1：Acceleration time
PQ1：Flow rate in
high pressure side PQ0：Deceleration time
12.3.3
[P40: PL_D] Settings when operating only at high pressure side (single)
If this parameter is set to "1: high pressure small capacity operation selection allowance", the lower limit of the
pressure setting of the low-pressure side will be 0.
Display Sign Parameter Name Range
Factory Default
Setting
Unit
P40 PL_D Pump operation selection
0: Disabled
1: High pressure small
capacity operation
selection allowed
0 -
Note The setting of this parameter will be enabled by turning on the power again.
12.4
Output signal Setting
The digital output, and the signal type can be selected by parameters, as shown in the table below.
12.4.1
Parameter
■
Parameters for output signal
Display Sign Parameter Name Range
Factory Default
Setting
Unit
P07 WN_M Warning output level 0
〜
2 0 -
P08 AMIX Alarm output mix 0
〜
2 1 -
P39 DO_S Digital output selection 0
〜 7
0 -