DACE RT25/50, Инструкция по установке и эксплуатации

Страница: 43 / 52

43
……..continued
NOTIFICATION MESSAGES
MESSAGE DESCRIPTION
MARKER OK
The Marker Magnet just passed the Marker Sensor and registered.
ARMED
One or more of the alarm inputs is armed and will trigger the alarm output if a valid
alarm condition occurs.
ADD A MINIMUM OF TWO
REMOTES TO MASTER
GROUP Some functions require a minimum of two remotes in the Master Group for safety
reasons. A remote belonging to the Master Group is sometimes needed to unlock a
feature e.g. locking the Remote Menu to prevent more remotes from being taught
to the system.
MENU LOCK
RELEASED
The Menu Lock was released. the menu may now be entered at any time. This will
happen if either the Menu Lock was disabled or there are less than two remotes
belonging to the Master Group.
PRESS MASTER GROUP
REMOTE BUTTON A button from a remote belonging to the Master Group must be pressed to contin-
ue the current operation.
RECEIVER LOCKED, ONLY
MASTER REMOTES AL-
LOWED If the receiver is locked, only remotes belonging to the master group will be allowed
to function.
BEAMS OK A beams Self Test was performed and the beams are working.
NO TIME PERIODS IN
MEMORY
The user wanted to clear a time period but there aren’t any in memory.
NEW TX LEARNED A new remote or device was learned to the controller.
AUTO LEARN MODE
EXITED
The Auto Learn time expired or the user manually exited Auto Learn mode that was
previously enabled.
SAVING FILE A file is being saved to the USB device.
LOADING FILE A file is being loaded from the USB device.
ACTION FAILED The user tried to save a file to, or load from, the USB device but something went
wrong.
FLASH DRIVE NOT READY There is either no flash drive in the USB port or the flash drive is not formatted using
the FAT file format.
REMOTE ACTIVATION
A remote signal was received. The remote number, group and function is displayed.
LIMIT RESET An end stop limit was reached before expected. Based on this limit position the
controller has adjusted it’s end stop position.
RUN SETUP
WIZARD FIRST
The operator cannot be used until the Setup Wizard is run.
ANNUALLY

Many sealed lead acid batteries do not last for more than one year. The battery condition can be checked by
disconnecting the mains supply to the operator. Go to Quick NAV on the LCD screen and press the joystick to
enter the Info menu. Run the gate at least five times and then read the battery voltage (BATT. V) to make sure
the battery is holding charge. The voltage should read 11.8V or more for a 12V battery and 23.6V or more for a
24V battery.
REMEMBER TO SWITCH THE POWER BACK ON!

Check all guide rollers on the gate.

Check all brackets and theft deterrent devices are secure.

Check the motor is firmly in place and cannot move.

Check the rack for any damage.
Continues……...