12
1.
Raise the adjusting nuts ~ 5mm before mounting the
operator to allow for fine height adjustment at a later
time.
2.
Mount the operator on the foundation plate.
3.
Place a Spirit Level on top of the operator base while
fastening the three securing nuts and washers ensuring
that the operator is level.
4.
Manually move the gate fully open and closed very
slowly to ensure that the gate does not collide with
the operator in any way.
5.
Be sure to remove any cement/debris around the pinion
gear.
Mount the operator above the flood level or, if this is
not possible, build a small protective wall structure
in front of the operator to divert the water flow.
SIDE VIEW
Adjusting Nuts
Operator
base
SECURE OPERATOR TO THE FOUNDATION PLATE
MOUNTING THE RACK ON THE GATE
Spacing between the Rack and the Pinion
DACE Grey Nylon Rack
This rack has a 2mm ‘built in spacer’
and therefore the mounted rack
should rest on the pinion.
All Other Nylon Rack
There must be a 2mm clearance
between the mounted rack and
the pinion
2mm
2mm Built
in Spacer
Continues……...
Spirit Level
Securing Nuts
Содержание RT25/50
