xStack
®
DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
config stacking mode
Purpose
Used to configure the stacking mode.
Syntax
config stacking mode [disable | enable] {<string>}
Description
This command will enable or disable the stacking mode for the switch. When enabled,
the 10G ports on the rear of the switch will be enabled for stacking.
Parameters
enable | disable
– Use these parameters to enable or disable the stacking mode for the
switch. Once this command is executed, it will cause the switch to reboot. This mode
cannot be changed when the switch is currently stacked with other switches.
<string>
– This parameter is used to perform the command without prompt if a user
enters /
y
for yes
or /
n
for no.
Restrictions
Only Administrator-level and Operator-level users can issue this command.
NOTE:
Only ports 26 and 27 of the DGS–3427 support stacking. Port
25 cannot be used for stacking, and is to be used only as a 10–
Gigabit uplink port.
Usage example:
To disable the stacking mode:
D G S – 3 4 2 6 : 5 # c o n f i g s t a c k i n g m o d e d i s a b l e
C o m m a n d : c o n f i g s t a c k i n g m o d e d i s a b l e
C h a n g e B o x b o o t m o d e m a y c a u s e d e v i c e s w o r k r e s t a r t , s t i l l c o n t i n u e ? ( y / n ) y
show stacking mode
Purpose
Used to view the current stacking mode.
Syntax
show stacking mode
Description
This command will display whether the current stacking mode is enabled or disabled.
Parameters None.
Restrictions None.
Usage example:
To view the current stacking mode:
D G S – 3 4 2 6 : 5 # s h o w s t a c k i n g m o d e
C o m m a n d : s h o w s t a c k i n g m o d e
S t a c k i n g m o d e : E n a b l e d
D G S – 3 4 2 6 : 5 #
show stack_device
Purpose
Used to display the information for stacking devices.
Syntax
show stack_device
Description
This command will display stack device information.
Parameters None.
Restrictions None.
33
