xStack
®
DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
255
D G S - 3 4 2 6 P : 5 # s h o w i p r o u t e s t a t i c
C o m m a n d : s h o w i p r o u t e s t a t i c
R o u t i n g T a b l e
I P A d d r e s s / N e t m a s k G a t e w a y C o s t P r o t o c o l B a c k u p S t a t u s
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
1 0 . 0 . 0 . 0 / 8 1 0 . 1 . 1 . 2 5 5 1 S t a t i c P r i m a r y I n a c t i v e
T o t a l E n t r i e s : 1
D G S - 3 4 2 6 P : 5 #
create ipv6route
Purpose
Used to create IPv6 route entries to the Switch’s IP routing table.
Syntax
create ipv6route [default |<ipv6networkaddr>] [<ipif_name 12> <ipv6addr>|
<ipv6addr>] {<metric 1-65535>}
Description
This command is used to create an IP route entry to the Switch’s IP routing table.
Parameters
default–
Use this parameter to create a default static IPv6 route entry in the Switch’s IP
routing table.
<ipv6networkaddr>
−
IPV6 address and netmask of the IP interface that is the destination
of the route. Specify the address and mask information using the format as ipv6address /
prefix_length (ipv6address is hexadecimal number, prefix length is decimal number, for
example 1234::5D7F/32).
<ipif name 12>
−
Enter the corresponding IPIF name of the IPv6 addres.
<ipv6addr>
−
IPv6 address for the next hop router.
<metric 1–65535>
−
Allows the entry of a routing protocol metric entry, representing the
number of routers between the Switch and the IP address above. The default setting is 1.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example usage:
To add a single static IPv6 entry in IPv6 format:
D G S – 3 4 2 6 : 5 # c r e a t e i p v 6 r o u t e 1 2 3 4 : : 5 D 7 F / 3 2 2 D 3 0 : : A C 2 1
C o m m a n d : c r e a t e i p v 6 r o u t e 1 2 3 4 : : 5 D 7 F / 3 2 2 D 3 0 : : A C 2 1
S u c c e s s .
D G S – 3 4 2 6 : 5 #
