D-Link DXS-3600-16S, Руководство пользователя

Страница: 535 / 695

DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
527
match ip next-hop { ACCESS-LIST-NAME | prefix-list PREFIX-LIST-NAME }
no match ip next-hop { ACCESS-LIST-NAME | prefix-list PREFIX-LIST-NAME }
Parameters
53-8 match ip route-source
This command is used to add a match command to match the source router IP address of the routes. Use the no form
of this command to delete the match command with source router IP address.
match ip route-source ACCESS-LIST-NAME
no match ip route-source
Parameters
ACCESS-LIST-NAME Specifies the name of a standard IP access list. The maximum length is 16
characters.
PREFIX-LIST-NAME Specifies the name of an IP prefix list. The maximum length is 16 characters.
Default None.
Command Mode Route Map Configuration Mode.
Command Default Level Level: 8
Usage Guideline The standard IP access list is created with the command ip standard access-list. The
prefix list is created with the command
ip prefix-list .
Only one of them can be supported for matching the next hop of routes at one time.
The next hop of routes is testes with the specified standard IP access list or prefix
list.
You can verify your settings by entering the show route-map command.
Example This example shows how to add a match command to match destination network
address of routes using standard IP access list.
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#ip standard access-list Strict-Control
DXS-3600-32S(config-ip-acl)#permit 10.1.1.0/24
DXS-3600-32S(config-ip-acl)#exit
DXS-3600-32S(config)#route-map rmap1 permit 10
DXS-3600-32S(config-route-map)#match ip next-hop Strict-Control
DXS-3600-32S(config-route-map)#
ACCESS-LIST-NAME Specifies the name of a standard IP access list. The maximum length is 16
characters.
Default None.
Command Mode Route Map Configuration Mode.
Command Default Level Level: 8
Usage Guideline The standard IP access list is created with the command ip standard access-list.
Only one standard IP access list is supported. If this command is executed with a
different standard IP access list, the old one will be overwritten.
You can verify your settings by entering the show route-map command.