DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
511
52-6 ip rip receive version
This command is used to specify the version of RIP packet received on an RIP interface. Use the no form of this
command to restore to the default value.
ip rip receive version [1 | 2]
no ip rip receive version
Parameters
Usage Guideline
Use the no form of this command to prevent from receiving RIP packets on the
interface, the RIP protocol should not receive the packets coming from the interface.
On one interface whose sending packets is disabled or Version 1, disabling receiving
packets will cause the configuration of authentication on this interface to be cleared
and can’t be restored when enable interface receiving packets again. The
authentication needs to be reconfigured.
With the no form of this command, the configuration set by
ip rip receive version
command will be cleared. After enable interface receiving packets again, the receive
version of the interface depends on global version setting with the
version
command.
You can verify your settings by entering the
show ip rip interface
command.
Example
This example shows how to configure the interface ‘vlan1’ to not receive RIP
packets.
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#interface vlan 1
DXS-3600-32S(config-if)#no ip rip receive enable
The configuration of authentication is cleared because only Version 2 supports authentication.
DXS-3600-32S(config-if)#
1
(Optional) Specifies to accept RIP Version 1 packets on the interface.
2
(Optional) Specifies to accept RIP Version 2 packets on the interface.
Default
None.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 8. (
EI Mode Only Command
)
Usage Guideline
Use this command to override the default behavior of RIP as specified by the version
command. If the interface receive version isn’t specified, it should depend on the
global version setting. This command applies only to the interface being configured.
You can configure the interface to accept both RIP Version 1 and Version 2.
When the send state is disable or send version is Version 1, Configure the receive
version to Version 1 should cause the configuration of authentication cleared,
because authentication just exist when the interface send and receive version is
Version 2.
You can verify your settings by entering the
show ip rip interface
command.
Содержание DXS-3600-16S
