D-Link DXS-3600-16S, Руководство пользователя

Страница: 14 / 695

DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
6
802.1X Commands
2-1 dot1x default
This command is used to reset the IEEE 802.1X parameters on a specific port to their default settings.
dot1x default
2-2 dot1x port-control
This command is used to manually control the authorization state on a specific port. Use the no form of this command
to reset the authorization state of the specific port to its default state (auto).
dot1x port-control {auto | force-authorized | force-unauthorized}
no dot1x port-control
Parameters
Parameters None.
Default Port control mode - Auto
Port PAE type - None
Port control direction - Both
Quiet period when authentication fails - 60 seconds
Re-authentication interval when authentication succeeds - 3600 seconds
Default timeout value waiting for a response from RADIUS - 30 seconds
Default timeout value waiting for a reply from Supplicant - 30 seconds
Default transmission interval from the Authenticator to the Supplicant - 30 seconds
Default maximum number of authentication request - 2 times
Re-authentication state on the port - Disabled
Command Mode Interface Configuration Mode.
Command Default Level Level: 8
Usage Guideline This command is used to reset all the IEEE 802.1X parameters on a specific port to
their default settings.
Example This example shows how to reset the 802.1X parameters on port 1.
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#interface tenGigabitEthernet 1/0/1
DXS-3600-32S(config-if)#dot1x default
DXS-3600-32S(config-if)#
auto Specifies to enable IEEE 802.1X authentication. The state (authorized or
unauthorized) for a specific port is determined according to the outcome of the
authentication.
force-authorized Specifies to force a specific port to change to the authorized state without an
authentication exchange.
force-unauthorized Specifies to deny all access on a specific port by forcing the port to change to the
unauthorized state, ignoring all authentication attempts.
Default The default authorization state is auto.
Command Mode Interface Configuration Mode.
Command Default Level Level: 8
Usage Guideline The configuration for this command on a specific port won’t be in operation if you
don’t configure the port as an IEEE 802.1X PAE authenticator by using the ‘
dot1x
pae authenticator ’ command.