8-port Gigabit Ethernet Switch User’s Guide
147
Figure 7-5. Factory Reset to Default Value screen
Select
Yes
if you want the Switch to retain its current IP address. Select
No
to reset the Switch’s IP address to the factory
default, 10.90.90.90.
Click the
Reset to Factory Default
button to restart the Switch.
Using Web-Based Management
Setting Up Web Management
Before running Web-based management, some basic configuration of the Switch may need to be performed. The following
at a minimum must be configured or known for the Switch to be managed:
•
IP Address
•
Administrator password
In addition, several other parameters may need to be configured or known to properly communicate with the switch or
allow full management capability. These include:
•
Default Gateway
•
Trap Destination and Community Name
Configuration of these items may be made from the User Interface, which is accessible via either the serial console or
Telnet. Refer to the User Guide that came with your system for more information that describes the required configuration.
Setting an IP Address
The IP address for the Switch must be set before it can be managed with the Web-based manager. The Switch IP address
may be automatically set using BootP protocol, in which case the actual address assigned to the Switch must be known.
The IP address may alternatively be set manually as follows
:
Содержание DGS-3308 Series
