CTC Union FRM220-100AS-1, Руководство пользователя

Страница: 59 / 83

59
CHAPTER 4
PROVISIONING VIA WEB BASED MANAGEMENT
2. SNMP – The allowed SNMP managers, community strings and Trap Managers are set here. There
is also a 'System Log' which can be viewed by selecting System Log under the SNMP main menu
item.
3. The actual
100AS-1 local, can be entered for configuration with this menu item.
4.3 System
The following page is an example of the 'System' screen of 100AS-1 . There are three 'Tabs' for
different setting windows.
4.3.1 Setup
The 'Setup' tab contains the networking settings for IP address, subnet mask, default gateway,
hostname, TFTP server IP and image upgrade filename. After filling in, click the 'Apply Parameters'
button.
4.3.2 Alias Information
Alias Information allows the user to enter identifying names to the local and/or remote devices.
These alias names will be displayed on the front panel graphics when viewing the System Panel
page. The alias names may contain up to 10 ASCII characters.
4.3.3 Parameter Management
Parameter Management is provided and allows configuration settings to be downloaded from
100AS-1 (saved remotely on PC) or uploaded (restored) to an 100AS-1 . Parameter Management
can be used to backup configuration data and allow quick recovery in case of hardware failure. It
can also be used to clone configuration data quickly on different
100AS-1 units.
The ‘Apply Parameters’ button will immediately write all changes to 100AS-1 device.
The ‘Reboot’ button will force a cold start of
100AS-1 and should be used with caution.
Caution should be exercised when doing a system reboot as all traffic through all ports
of the device will be blocked until the switch chip is initialized. In addition, the OAM
discovery and negotiation will need to redo. If enabled, STP (Spanning Tree Protocol)
discovery will need to rebuild path tables.
The ‘Refresh status’ button will update the display with any status changes.