Crystal Vision
Appendix 1
7
Appendix 1
7.1 Module addresses and node numbers
The following table shows the Upper/Lower address or slot number range on the
panel PIC, PSUs and installed modules for a variety of Indigo frames.
Device/Indigo frame
Lower address in 1
st
frame
Modules in 2U frames
to 1.12
Modules in 1U frames
1.01 to 1.06
Modules in desk top
frames
1.01 to 1.02
Panel PIC in all frames
1.00
Upper PSU in 2U frames
1.14
Lower PSU in 2U frames
1.15
PSU in 1U frames
1.14
Most Crystal Vision cards have their unique node or card location address assigned
automatically by the panel processor based on the slot occupied in the frame and the
Upper/Lower range address setting.
Older cards may have a special 16-position node switch for use with older frames
such as the FR2-12 or FR1-6.
In all of the current frames, this node switch should be set to zero (factory
default).
When a card is detected by the front panel processor, some older cards will identify
their location with a node address instead of a slot address.
The relationship between the two methods of referring to card addresses is as
follows.
In the Indigo desk top box the node address is calculated as follows:
•
slot number minus 1 – giving a range of 0 - 1 in frame 1 and 16 - 17 in
frame 2
In the 1U frame the node address is calculated as follows:
•
slot number minus 1 – giving a range of 0 - 5 in frame 1 and 16 - 21 in
frame 2
In the 2U frame the node address is calculated as follows:
•
slot number minus 1 – giving a range of 0 - 11 in frame 1 and 16 - 27 in
frame 2
Indigo DT User Manual R1.8
33
05 July 2018
