Crystal Vision
Installing Crystal Vision modules
Rear connectors
The frame will be supplied with an appropriate selection of rear connectors for any
cards installed in it at the time of order. Unused slots will be fitted with a blanking
plate.
Details of signal types and pinouts are given the documentation supplied with each
Crystal Vision video or audio card.
The Indigo DT rear view with EMC cover removed for slots 1 and 2
The rear modules are held in place by retaining screws which ensure EMC
compliance.
To access the rear connector motherboard the appropriate EMC covers and retaining
screws must be removed.
Fitting rear connectors
To fit a rear connector, proceed as follows:
•
Disconnect the mains power lead from the frame
•
Remove the rear relevant EMC cover(s) at the rear of the frame by
unscrewing the retaining screws.
•
Push fit the selected rear connector onto the appropriate frame slots
•
Refit an EMC cover if required and replace the retaining screws.
The Indigo DT with one EMC cover and an RM01 connector fitted to slot 1
Warning:
To maintain product safety and EMC compliance the rear of the frame
should be filled with Crystal Vision rear connectors and/or EMC covers
and held in place with retaining screws before power is reapplied.
4.1 Select the cooling mode
There are three cooling modes that can be selected using a switch at the rear of the
control panel.
Indigo DT User Manual R1.8
27
05 July 2018
