Crystal Vision
Installing modules
Inserting modules
To insert a module proceed as follows:
•
Remove the two screws holding the bracket adjacent to the slot intended for the module
and keep both the screws and bracket in a safe place
•
Insert the module into the appropriate guides and push it fully home
•
Refit the retaining brackets if required
The Indigo 1 frame with two modules fitted in slots 1 and 2
Removing modules
To remove signal modules simply pull on the handle and withdraw them from the frame, with
the retaining brackets removed.
All Crystal Vision cards can be inserted and removed whilst the frame is powered without
damage.
3.2 Rear connectors
The frame will be supplied with an appropriate selection of rear connectors for any cards
installed in it at the time of order. Unused slots will be fitted with blanking plates.
Details of signal types and pinouts are given in the documentation supplied with each Crystal
Vision video or audio card.
The Indigo 1SE frame rear view with EMC covers removed for slots 1 and 2
The rear modules are held in place by a screw at each side to ensure EMC compliance.
To access the rear connector motherboard the appropriate EMC covers and fixing screws
must be removed.
Indigo 1 User Manual R1.14
18
27 February 2020
