14 • HD-RX-4K-x10-C-E(-SW4)
Web Interface Configuration Guide — Doc. 9211A
Routing
The Routing page can be used to automatically or manually route input(s) on the receiver (local
inputs) or any DM Lite transmitter input (remote inputs) to the HDMI output. The default input
and output names also can be changed if desired.
The Routing page can be accessed at any time by clicking the ROUTING tab in the navigation bar
of the web interface.
The default name of the HDMI output of the HD-RX-4K-x10-C-E(-SW4) is HDMI Output. The
default names of the local HDMI inputs on the receiver are HDMI1 and HDMI2. The default
names of the remote inputs range from DM Lite 3 to DM Lite 4 for the HD-RX-4K-410-C-E(-
SW4) or DM Lite 5 for the HD-RX-4K-510-C-E(-SW4).
Move the Auto Route slider to Enabled or Disabled to specify whether automatic input routing of
inputs will be enabled or disabled. When automatic input routing is enabled and Priority Routing
is disabled, the HD-RX-4K-x10-C-E(-SW4) will do the following:
l
Automatically route the last connected input.
l
Remember the order in which sources were connected to the inputs; the device will update
its connection order status if a non-routed source is disconnected.
NOTE:
Auto Route mode can be set from the front panel, SIMPL program, or the web
configuration interfaces of the HD-RX-4K-x10-C-E(-SW4), as well as the transmitter.
To manually route a local input to the output, select the radio button next to the name of the
corresponding input. The input is routed to the output.
When routing DM Lite inputs, select the desired DM Lite transmitter input from the
corresponding drop-down list. If the DM Lite transmitter is not connected, the drop-down
selection menu is grayed out and displays Not Connected.
Click Clear Route to clear the route.
