Contec VPC-2000, Руководство пользователя

Страница: 135 / 144

Chapter
８
Hardware RAID setup
◆RAID setup when replacing the HDD
This section describes the setup for replacing a mirroring-configured HDD. Set it up
along the number of exchanged HDD.
Prepare a HDD for replacement with the same type and capacity.
●When replaced HDD is one
Prepare a good HDD and replace a faulty HDD with it. Regarding replacement of HDDs, refer
to Chapter 3 “Setup of Hardware” – “Installation of Hard Disks”.
After replacement of a HDD, rebuilding will be automatically started. The table below
shows when a HDD connected to Drive2 is replaced. If a HDD connected to Drive1 is replaced,
the indication given by the utility and the statuses of Drive1 and Drive2 will be
reversed.
Table 8.8 To have mirroring reconfiguration
Rebuilding After rebuilding
Utirity
※Replacing a HDD connected to Drive2
After checking a HDD for replacement, replace it. Replacing a normal HDD with a faulty
HDD may halt and damage the system.
If rebuilding is not automatically started, refer to This Chapter “Troubleshooting”.
If rebuilding doesn’t end normally, refer to This Chapter “Troubleshooting”.
User’s Manual
129