Contec VPC-2000, Руководство пользователя

Страница: 116 / 144

Chapter
７
Software RAID setup
The number of HDDs necessary for setting “RAID1(Mirror)” for the “RAID Level” setting
is two. If only two HDDs are connected, the “Disks” setting cannot be selected, so
go to step 7. If more than two HDDs are connected, it will be necessary to set up the
HDDs comprising a mirroring RAID drive on the following screen, so proceed to step 4.
Port Drive Model Serial # Size Type/Status(Vol ID)
* *********** ************* ***GB Non-RAID Disk
* *********** ************* ***GB Non-RAID Disk
* *********** ************* ***GB Non-RAID Disk
Select 2 disks to use in creating the volume.
[ SELECT DISK ]
[
↑↓
]-Prev/Next [SPASE]-SelectDisk [ENTER]-Done
4. Select the “Select Disk“ setting by pressing the <Enter> key, and select the HDDs
comprising the RAID drive by pressing the <SPACE> key.
5. Press the <Enter> key to close the “SELECT DISKS” window.
6. You can optionally configure other settings. “Name” and “Capacity” can be set
by keyboard entry.
7. Once setting up the RAID drive is complete, press the <Enter> key with “Create
Volume” selected.
8. When you are prompted to confirm that you are creating a RAID drive, press the <Y>
key.
9. A RAID drive will be created under “RAID Volume” in the Main window. The
“Type/Status(Vol ID)” of the HDDs will read “Member Disk”.
10. Press the <↑> and <↓> keys to select “Exit” in the Main window, and confirm your
choice by pressing the <Enter> key or the <5> key.
11. When you are prompted to confirm that you are saving the current settings, press
the <Y> key to exit the RAID utility.
Mirroring requires the creation of a RAID drive before installing the OS. If a RAID
drive is created after installing the OS, data will be lost and the OS will be unable
to boot.
Our support is limited to mirroring. Creating a RAID drive other than a mirroring
RAID is up to the customer. We assume no responsibility for damage caused by doing
so.
110
User’s Manual